Setup guide

ElitePro Setup Guide

Step 8

Using Drive Assigner to select Recording Drives & Printing Port

From the factory, your duplicator is set to use the correct recorder drives and printer port.

However, if you ever reinstall or upgrade the DiscJuggler software, it will be necessary to run

Drive Assigner to select the CD recording drives and printing port to use with the autoloader.

To run Drive Assigner, select Start, All Programs, Padus DiscJuggler, and click on

Drive Assigner. DiscJuggler will review the system and display the devices that it has located.

Select the writers that are located in the autoloader unit by clicking on the boxes beside the

drives. Do not select any CD ROM drives. Also, select the appropriate printing port for

DiscJuggler to use when printing CD labels. The FlexPrinter will use USB001. Click on

Update and then OK when finished with your selection. This process will assign only the

recorders of the autoloader to DiscJuggler and will set which port the software uses to

communicate with your CD printer. The assignment will remain set unless you run the Drive

Assigner again and change your settings.