Setup guide

Elite Setup Guide

Step 2

Installation of CD Pick Arm

The CD Pick Arm needs to be installed onto the rotate arm. Remove the pick arm from the

bubble wrap packaging. Included with the arm will be a bag containing two black plastic

retainers. These retainers are used to hold the pick arm onto the rotate arm.

Hold the pick arm in one hand. Place the arm onto the slotted resting tray on the upper section

of the column. Plug in the RJ12 (telephone) type connector (NOTE: MAKE SURE THE

CONNECTOR RETAINER HAS SNAPPED INTO PLACE BY PULLING GENTLY ON THE

CABLE).

Then secure the arm into place by pressing a retainer into each side of the pick arm.

These steps can be reviewed in the pictures shown below.

The pick arm should freely float or pivot from the point where the retainers were installed.

Locate Pick Arm & Retainers

Step 1

Hold Pick Arm in Place & Connect RJ12 Connector

Step 2

Install / Press in the Black Plastic Retainers

Step 3

The Pick Arm after Installation

Step 4