Setup guide

Elite Setup Guide
6
This brief setup guide is provided to get the Elite operational out of the box. Once you get the
system operational, complete online help can be accessed from the DiscJuggler HELP
Section.
Step 1
Unpacking the Hardware :
Your system was shipped in 1 box and contains the Elite unit, Firewire PCI Card and cables. If
you purchased the CD Printer, it was shipped in a separate box.
Carefully open the box and remove the top protective cardboard sheet. You will then be able
to remove the following:
CD Pick Arm
FireWire PCI Card Box
Printer Control Cable
Printer USB Cable
DB9 Serial Loader to PC Cable
AC Power Cord
Software and Manual
Set the components on a table that will hold the E lite unit and your PC. Next, by lifting straight
up, carefully remove the foam container and foam protection over the Elite unit. You will see
the Elite in a plastic bag. The Elite has lifting hand holders on either side, locate these and
remove the Elite from the box. Remove the Elite out of the bag and place all shipping
components back into the shipping carton for future use. It is important to always ship the Elite
in its proper container so storage of the box and accessories is important. In the event you
misplace your packaging and need to ship the Elite contact the service department and a new
shipping container will be shipped out.
Next remove the printer from its shipping carton and place all the components on the table.
Account for all the components and proceed to installation of the CD Pick Arm.
Main Box Opened and
parts located in top section
Remove foam sections and
Access the Elite Main Unit
Locate Lifting handles on
the Elite Unit and lift out