Setup guide

Elite Setup Guide

Step 19

Start The Job

Now you are ready for the unit to start a job. Click on the

START

button.

The Elite should move to the input spindle, pick up the 1

CD (your master) and place it into

one of the recorders. The image on the CD will be copied to the hard drive. Then the CD

Master will be removed from the Drive and place on the output spindle. Then the Elite will

place a blank CD from the input spindle into each of your CD recorders. Next, the image will

be recorded onto the media. After that, the Elite will pick up the recorded disk from one of the

recorders and carry it to the top of the column and wait for the CD Printer to open. The

recorded CD will be placed into the printer tray and the CD will be printed. After printing, the

Elite will pick up the CD from the printer and place it on the output spindle. This will repeat for

each of your recorders. Once all your recorders are empty, the Elite will take more blank CDs

from the input spindle and reload the recorders. This cycle will continue until the 25 copies are

completed.

If the unit is trying to use a CD recorder on your PC, or if you get an error message when

trying to print, please read the

Using Drive Assigner

section located on the next page of this

guide for some steps to correct the problem.

Please observe the operation and verify that everything works smoothly. If anything does not

work, back track and review your steps. If you

cannot find the problem please call customer

service and one of our technical support staff will gladly assist.