Setup guide

Elite Setup Guide

Step 15

Loading Blank Media & Using DiscJuggler

Ensure that all the cables are properly connected. If you have not already done so, turn on

the Elite by pressing the

power switch

front right side

. A small green

LED located on the front of the unit should light up. If not, check to see that the power supply

located at the rear of the unit is turned on and that it is properly connected to a standard

working 115V power outlet. You are now ready to start creating and duplicating CD/DVDs.

The next steps will take you through a typical

setup and usage of the Elite. It is recommended

to follow these steps and produce a test job, then move on to the many other functions and

features of the Elite.

Load blank Ink Jet media, data side down, onto the input spindle. The input spindle has three

silver rods located around the outside edge of the media. Please be sure the media does not

stick together and that the media lays flat in the input spindle. You may use the included gray

plastic alignment rod to help ensure that the CDs are properly aligned.

Place a CD-R to be copied on top of the blank

media in the input spindle. This will be

faster.

On the Desktop, click on the

DiscJuggler ICON

and the DiscJuggler will run.

Click on

File

, choose

New

and the panel below will open.

Choose

Copy CDs and DVDs from the same burner

(This task will take the CD on the top of the Input Stack; load a temp image to the hard drive

and copy from the temp image.)

Screen of Start of a New Job