Setup guide

Elite Setup Guide

Step 14

Using Drive Assigner to select Recording Drives & Printing Port

Before you can use the Elite to duplicate and print CDs, it is necessary to specify which

CD/DVD burners and printer port are to be used with the Elite. Ensure that all the cables are

properly connected. Turn on the Elite by pressing the

power switch

front right side

. A small green LED located on the front of the unit should light up.

To run Drive Assigner, select Start, All Programs, Padus DiscJuggler, and click on Drive

Assigner

DiscJuggler will review the system and display the devices that it has located.

Select the writers that are located in the Elite unit by clicking on the boxes beside the drives.

Do not select any non-writing CD ROM drives. Also,

select the appropriate printing port for

DiscJuggler to use

when printing CD labels.

The Autograph VI will use USB001. Click on

Update and then OK when finished with your selection. This process will assign only the

recorders of the Elite to DiscJuggler and will set which port the software uses to communicate

with your CD printer. The assignment will rema

in set unless you run the Drive Assigner again

and change your settings.