Setup guide

Elite Setup Guide
22
Step 12
Installation of Labeling Software
Locate the Discus CD Labeling Software CDR and insert into your CDROM drive on the PC
XXX-XXX-XXX. This key will be needed to complete the Discus installation.
The menu below will be displayed. Choose install to hard disk. If your CDROM drive is not set
to autoplay, open the CDROM and click on Launcher.exe . NOTE: Be sure that your PC can
handle the 500MB and not affect the minimum requirements of the Elite hardware.
When the Discus Labeling Software begins to install, it will first load Apple QuickTime onto
your PC. Following the instructions on the installation. When the screen asks to register the
QuickTime, simply click on Proceed without entering anything.
Once the Discus installation is complete, a DiscusLE icon will be placed on your desktop.
Click on the Discus LE icon and verify that the Discus installed correctly. The following screen
will appear. Type in your Discus key and click the OK button. Close Discus and remove the
CDROM.
Type in your Discus Key.