User`s manual

62 Creating Discs on a Mac
Image Alignment
The Image Alignment button will allow you to nudge the
image up, down, left, or right on your disc. To center the
image, click the Image Alignment button. You will be
prompted with a choice to print a test print or simply enter
values to nudge the image alignment on the disc.
If you do not know the direction and distance to move the
image in order to center it on your disc, you can opt to print
the centering test print. Make sure the Publisher has discs and
ink cartridges installed, and it is connected and ready to
receive a print job, and then click the Ye s button. The
Publisher will pick a disc and print a scale of numbers on it.
You will be prompted to open the Publisher's front
cover, rotate the printed disc 180 degrees, reload it
into the input, and close the cover. Click OK when
ready and the Publisher will pick the disc and
print another scale of numbers. The disc should
look like this:
Calibrate Last Disc
Use this calibration if you frequently receive false messages
that two discs were picked. Also, use this calibration if the
Publisher will not switch from the right bin to the left bin in
kiosk mode. When you press this button you will be prompted
to place one disc each in both the left and right bins. The
Publisher will then touch each disc with the robotic arm to set
the correct measurement for the last disc in the bin.
-5 -4 -3 -2 -1 0 1 2 3 4 5
5 4 3 2 1 0 -1 -2 -3 4 -5
Horizontal Calibration
Find and enter the number
whose lines tough
(must be the SAME number)
Vertical Calibration
Find and enter the number
whose lines tough
(must be the SAME number)
NOTE:
After printing this image
once, rotate this CD
so the ARROWS point
to the BACK of the printer
and print again.
-5
-4
-3
-2
-1
0
1
2
3
4
5
5
4
3
2
1
0
-1
-2
-3
-4
-5
BACK
BACK
510951new.qxd 5/8/2006 10:51 AM Page 62
TOC
INDEX