User`s manual

40 Creating Discs
Color+Black printing. It is important to perform this calibration
every time you change a cartridge. If you forget to perform this
calibration you will be prompted to do so before your first
print from the new cartridge.
Center Print Image
NOTE: Your printer comes from the factory pre-calibrated to print the image
to the center of the CD. You can use this adjustment if you need to
fine-tune this location.
If you ever wish to verify your factory-calibrated Vertical
and Horizontal calibration settings, you can run a simple
calibration procedure to assure that your images will be
centered when printed on a CD. To do this, refer to the
following steps:
1. Click Center Print Image in the Printer Settings Window.
2. Click Start Auto Calibration to begin printing
the calibration test print.
3. When the print is complete, rotate disc 180º
and put the disc back in the input bin and
repeat step 2 using the same disc.
4. When the second run of the print is complete, you should
have a test print that looks similar to the following:
-5 -4 -3 -2 -1 0 1 2 3 4 5
5 4 3 2 1 0 -1 -2 -3 4 -5
Horizontal Calibration
Find and enter the number
whose lines tough
(must be the SAME number)
Vertical Calibration
Find and enter the number
whose lines tough
(must be the SAME number)
NOTE:
After printing this image
once, rotate this CD
so the ARROWS point
to the BACK of the printer
and print again.
-5
-4
-3
-2
-1
0
1
2
3
4
5
5
4
3
2
1
0
-1
-2
-3
-4
-5
BACK
BACK
XRP.qxd 4/18/2011 2:55 PM Page 40
TOC
INDEX