User Manual

Printing from a PC 31
Adjust print alignment using the Status Monitor. Go to the
Alignment Tab (third tab).
Three items can be adjusted here:
 Tear off Position. This value adjusts the position of the last
label printed after it has been presented for tear off. This
only applies if the output mode is set to "Present the label."
Add to the current value to move the tear point closer to
the printer. Subtract from the current value to move the
tear point away from the printer. After adjusting the value
click the "Set" button to send the value to the printer.
 Left Margin Offset. This value moves the printed label
left or right. Add to the current value to move the printed
label to the right. Subtract from the current value to move
the printed label to the left. After adjusting the value, click
the “Set” button to send the value to the printer. Note:
Before adjusting this value make sure the label stock is
properly loaded so that there is no gap between the edge
of the liner and the fixed throat guide. Any gap at this
point will greatly affect the Left margin offset value
needed to align the label. Also, if you adjust the value
with improperly loaded label stock you will have to adjust
it again if you load the label stock correctly the next time.
 Top of Form (TOF). This value moves the print start
position up or down on the label. Add to the current value
to move the printed label down or toward the printer.
Subtract from the current value to move the printed label
up or away from the printer. After adjusting the value click
the “Set” button to send the value to the printer.
TOC
INDEX