Manualshelf

Installation manual

ManualsBrandsPrime Security ManualsAutomotivePrime AMX 38
71727374757677787980
-76-
10.7.3: SMS Center
To edit the SMS Center telephone number:
1. From the Programming menu, select Communications, Comm.
Options, GSM Options, SMS Center [954133].
2. Enter up to 16 digits. Use the
key to enter “*”, “#”, “,” (pause), “T”
(switch to DTMF tone dialing), “P” (switch to pulse dialing) or “+”
(international code). Use the
key to delete one character at a time.
3. Press when you have finished editing.
10.7.4: SMS Command
The SMS Command option enables you to enable or disable the ability to send
commands to the system via SMS. For further information on SMS commands, see 3.8:
Remote Arming/Disarming via SMS and 6.3: Telephone Control
To enable/disable SMS commands:
1. From the Programming menu, select Communications, Comm.
Options, GSM Options, SMS Command [954134].
2. Select Enabled or Disabled.
10.7.5: SMS Confirmation
After an SMS command is executed by the system, a confirmation message is returned
to the sender’s mobile phone. You can enable or disable this feature using this option.
To enable/disable SMS confirmation:
1. From the Programming menu, select Communications, Comm.
Options, GSM Options, SMS Confirm. [954135].
2. Select Enabled or Disabled.
10.7.6: GSM Media Loss Time
The GSM Media Loss is a feature that is designed to reduce the amount of GSM media loss
events registerred in the log and sent to the central station. This feature is recommended for
use in cases of wide fluctuation of GSM signal strength. GSM Media Loss is implemented
only when the Line Monitor feature is enabled (see 10.6.1: Line Monitor).
When the GSM signal strength has been below the lower threshold during time defined in
the GSM ML Time parameter, a GSM Media Loss event is registered in the log and sent
to the central station if PSTN module exists in your system configuration. When the GSM
sinal strength is restored and have been above the upper threshold during 3 minutes,
GSM Media Restore event will be registered in the log and sent to central station.
To set the GSM Media Loss Time:
1. From the Programming menu, select Communications, Comm.
Options, GSM Options, GSM ML Time. [954136].
2. Enter time (003-255 minutes or 000 to disable the GSM Media Loss
feature and cancel the GSM Media Loss events).
3. Press when the desired setting is displayed.