Installation manual
-71-
10.4.2: RP Passcode
The RP passcode is a six-digit code that grants access to remote programming. When
establishing an RP connection, the passcode programmed in the RP customer file on the PC
must be identical to the system’s RP passcode.
To edit the RP passcode:
1. From the Programming menu, select Communications, Remote
Prog., RP Passcode [9522].
2. Enter six digits.
3. Press when you have finished editing.
10.4.3: RP Communication Interface
The infinite prime can employ either cellular or PSTN communication during
remote programming.
For PSTN communication, the RP uses a double call method so that the line can
be shared with regular telephone handsets, an answering machine or fax. The
Cellular Communications Module has its own individual telephone number for data
transfer and therefore, the double call method is not needed. In this case, the RP
calls the control system directly.
To program the RP communication interface:
1. From the Programming menu, select Communications, Remote Prog.,
RP Interface [9523].
2. Select either GSM or PSTN.
10.4.4: RP Access Options
Options are available to enable, disable or limit access to remote programming.
To program RP Access Options:
1. From the Programming menu, select Communications, Remote Prog.,
RP Access [9524].
2. Select an RP access option from the following table.
Access option Description
Always Enable Up/downloading is always possible.
During Disarm The system must be disarmed in order to establish a connection.
Disable Up/downloading is disabled.
User Initiated The user must perform Enable Programming from the Service menu
in order to establish a connection – see 4.7.11: Enable Programming.
Table 10.2: RP Access Options
10.5: Service Call
The Service Call feature is designed to enable the user to call the monitoring service at
the push of a button. When the user presses and holds down the Service Call button (0)
for a few seconds, a two-way audio connection is established with the central station.
10.5.1: Service Call Telephone Number
To edit the Service Call telephone number:
1. From the Programming menu, select Communications, Service Call,
Phone Number [9531].