Installation manual

-60-
To edit the Banner text:
1. From the Programming menu, select System Options, Display, Banner [94062].
2. Edit the Banner text using the alphanumeric keypad.
3. Press  when you have finished editing.
,
The system never displays the Banner text if the Arm Status Display option is
programmed as Always.
9.6.3: Time/Date Format
This option determines the format in which the time and date are displayed.
The following options are available:
• DD/MM/YY, 24Hr
• DD/MM/YY, 12Hr
• MM/DD/YY, 24Hr
• MM/DD/YY, 12Hr
To program the Time/Date format:
1. From the Programming menu, select System Options, Display, Time
Format [94063].
2. Select the required format from the options available.
9.6.4: Supervision Loss Indication
This option enables you to select whether transmitter supervision loss shall be indicated
to the user in the system trouble display .
To program the Supervision Loss Indication setting:
1. From the Programming menu, select System Options, Display, SV Loss Ind. [94064].
2. Select Enabled or Disabled.
9.7: PGM Output Options
The PGM is a programmable output that is triggered according to specific system status
conditions, or by remote command sent via PSTN, GSM, keyfob, keypad, or RP.
9.7.1: Output Trigger
The Output Trigger option determines the conditions that activate and deactivate the
PGM output.
To program the Output Trigger:
1. From the Programming menu, select System Options, PGM Options,
Output Trigger [94071].
2. Select an Output Trigger option from the following table.