Installation manual

-51-

7.9: Repeaters

Repeaters are designed to extend the wireless range of the control system. Up to

four repeaters may be registered to the system with a maximum of 32 transmitters

associated with each receiver. For information on registration, descriptor editing

and deletion, 7.1: Device Registration, 7.2: Device Descriptors, and 7.3: Device

Deletion , respectively.

7.10: Wireless Siren

For the wireless siren to function, the control system must have the on-board transmitter

installed on the Main board – see 1.4.1: The Main Board for the location of the on-board

transmitter connector.

Using this transmitter, the system sends alarm and arm status information to the

wireless siren’s receiver. This requires that you register the transmitter to the

wireless siren’s receiver.

To register the on-board transmitter to the wireless siren’s receiver:

1. Set the wireless siren’s receiver to Registration mode – refer to the

siren’s installation instructions for further information.

2. Activate the siren using the WL Siren Test feature – see 4.7.3:

Wireless Siren Test.

3. Activate the siren again; the on-board transmitter is registered to the

siren’s receiver.

When installing 2-way sirens, the wireless siren also includes a transmitter that must be

registered to the control system. For information on registration and deletion, see 7.1:

Device Registration and 7.3: Device Deletion, respectively.

7.10.1: Wireless Siren Type

The control system supports both 1-way and 2-way wireless sirens. For this feature to

function correctly, you must define the wireless siren type in programming.

The following options are available:

• 1-Way Siren – if using the infinite-WSM, EL-2626WSM wireless siren

or EL-2525 status indicator.

• 2-Way Siren – if using the EL-2626AC wireless siren.

• 2-Way Siren/Kpd – if using the EL-2626AC wireless siren and the 2-

way EL-2620SI keypad (future option).

To program the wireless siren type:

1. From the Programming menu, select Devices, Siren, WL Siren

Type [9152].

2. Select a siren type or No WL Siren if no siren is installed.