Installation manual

-38-
To make a Telecontrol call:
1. Call the control system either using the double call method (PSTN) or
directly (Cellular); when the control system picks up, two DTMF tones
are sounded.
2. Enter the Telecontrol code (Code 29) on your telephone within 15 seconds.
,
Do not enter your user code until you hear the two DTMF tones. Any digits entered before
the tones are sounded are disregarded by the system.
3. A DTMF tone is sounded to indicate that the system is ready to
receive commands.
The following DTMF commands are available:
Press "2" for Two-Way Audio.
o If the TWA mode is defined as
“Simplex” (see 10.6.12: TWA Mode),
the audio channel opens in Listen
mode (microphone active/speaker
mute). To switch to Speak mode,
press “1” on your telephone. To
switch back to Listen mode, press “0
on your telephone.
Press "3" to fully arm the system.
Press "4XX" to turn HA unit #XX ON.
Press "430" to activate PGM output (Unit 30)
Press "5XX" to turn HA unit #XX OFF.
Press "530" to deactivate PGM output (Unit 30)
Press "6" to disarm the system.
Press "9" to cancel the siren.
,
The commands "3" (Full Arm),"4" (HA/PGM On), "5" (HA/PGM Off), "6" (Disarm) and "9"
(Bell Cancel) can also be executed at any time during a Two-Way Audio session.
,
Error beeps (three DTMF tones) are sounded in case of a wrong DTMF command.
,
To clear the last command, press @ or #”.
,
PGM Output is defined as HA Unit 30
4. The duration of the call is determined by the TC/VM Timeout (see
10.6.11: Telecontrol/Vocal Message Timeout). Ten seconds before the
timeout expires, two short DTMF tones are sounded. To extend the call,
press “7” on your telephone. This command restarts the timeout.
5. To disconnect before the end of the timeout, press “@” then “#” on
your telephone.
5.1.5: Arm/Disarm DTMF Commands
During a Telecontrol call, you can arm and disarm the system remotely using the DTMF
commands “3” (Arm) and “6” (Disarm). When arming the system in this way, the system
is armed immediately without an exit delay.