Installation manual

ManualsBrandsPrime Security ManualsAutomotivePrime AMX 38

-34-

To record a message:

1. From the Service menu, select Messages, Record Message [7022].

2. Press  to start recording the message.

3. Record your message. The message may be up to twenty seconds long.

4. Press  to stop recording; the message is automatically played back

and OK? is displayed.

5. Press  to save your recording.

To delete a message:

1. From the Service menu, select Messages, Delete Message [7023];

OK? is displayed.

2. Press ; the message is deleted.

The Record and Play options can also be accessed via a convenient shortcut without

needing to enter a valid user code. To access the Record Message option from

Standby mode, press



then



. Record your message, press



. The message is

then recorded, played back and saved. To access the Play Message option from

Standby mode, press  then .

4.7.3: Wireless Siren Test

To test the wireless siren:

• From the Service menu, select WL Siren Test [703]; the external siren

is sounded briefly.

4.7.4: Siren Test

To test the control system’s built-in siren:

• From the Service menu, select Siren Test [704]; the control system’s

built-in siren is sounded briefly.

4.7.5: Interface Test

The Interface test enables you to check if the speaker, LEDs and LCD are

functioning correctly.

To test the system interface:

• From the Service menu, select Interface Test [705]; a short sequence

of chimes are sounded from the speaker, all LEDs flash and the LCD is

tested on all connected LCD keypads.

4.7.6: Walk Test

To initiate Walk Test mode:

1. From the Service menu, select Walk Test [706]; a list of registered

sensors appears.

2. Trigger each sensor; when the system receives a successful

transmission from a sensor, the sensor is removed from the list.

3. When all the sensors are removed from the list, End Walk Test

is displayed.

4. Press  to exit Walk Test mode.

4.7.7: Transmitters

The Transmitters menu offers two utilities that serve as a valuable aid during installation. The first

utility, TX List, is a scrollable inventory of all registered transmitters and their last reported status.