User's Manual

11
☆ 建议使用大品牌的存储卡，以避免卡的不兼容。 
☆ 建议使用 CLASS8 以上存储卡，这样可以获得较快的传输速率.
☆ The device supports a maximum 32GB microSD card.
Insert your card into the microSD slot until it clicks into place. It’s OK.
Remove microSD Card
Close all applications or document s which have been opened on the card. Tap
→ Settings →
Storage →SD card → Unmount this storage device. When it displayed “Mount this device” and then
press t he card lightly; it is partially ejected allowing you to pull the card out.
☆ Don’t insert and remove the U-disk repeatedly in a short time, as this may cause damage to the card.
☆ We recommend using maj or brands of memory cards to avoid incompatibility.
☆ We recommend using CLASS 8 above memory card to get faster transfer rate.

3 .6 开始使用
3 .6
GETTI NG STARTED
给设备充电
☆ 不建议在充电的同时使用设备。 
电源适配器一端接插座，一端接设备的电源插孔即可对设备进行充电。(关机状态下充满
约需 4.5 小时)
Chargethedevice
☆ Itisnotrecommendedtousethedevicewhilecharging.
Plugthepoweradapterintoanelectricalwalloutlet,andthenconnecttothedevicetofullychargethebattery
beforeuse(Afullchargetakesabout4.5hoursintheof fsta tus).
启动设备
长按电源键 2 秒。
Turnthedeviceon
Press&holdthepowerbutton2seconds.

W i- Fi 网络设置
由于许多功能都需要有 Wi‐Fi 连接，所以建议您使用前先设置 Wi‐Fi 网络。
1．点击
→ 设置。
2．将 Wi‐Fi 右侧按钮滑动至
打开 状态。
3．设备将会自动搜索并列出所有能用的 Wi‐Fi 网络。如果 Wi‐Fi 图标右下角有锁，
则需要输入密码才能进行连接。
4．点击你想要连接的 Wi‐Fi 网络
→ 如果有密码则需要输入密码 → 点击连接。
5．点击
返回到桌面。