User's Manual

- 2 -
Installing Your Mouse
1. Hardware Installation
To connect your PS/2 Mouse
Note: Before coneect the mouse to your system, please make sure your computer is off.
1. Turn off your computer.
2. Connect the mouse cable to the PS/2 (6-pin) mouse port.
3. Turn on the computer.
To connect your USB Mouse
Note: To use the USB mouse, you need to have Windows 98 / ME / 2000 / XP (recommended)
installed on your computer.
1. You don’t need to turn off your computer before connect your USB mouse.
2. Plug the rectangular USB mouse connector into the USB port (normally in the back of the
PC).
3. Insert the software diskette into your disk drive and follow the onscreen instructions to install
the device driver.
2. Installing MouseSuite
™
Software
Important: If you are installing your mouse on a Windows NT / 2000 / XP system,
please make sure you log in with Administrator right before proceeding.
The Mouse Suite
™
Software must be installed in order to use all of the features of your
new mouse. Please use the following guide to properly install the Mouse Suite
™
software.
1. Start Windows and insert the Mouse Suite
™
installation software into the appropriate drive.
2. Click Start on the Task Bar and select Run.
3. From the Run dialog box, enter: <drive>:\Setup, and click OK. For example, if the setup disk
is in drive A, type a:\setup.
4. Follow the on-screen instructions to complete the software installation.