User Manual

The mouse does
not move smoothly
after returning from
the power saving
mode.
→Deactivate the Bluetooth connection, wait a few
seconds, and then reestablish connection.
The mouse is not
found when the
Bluetooth device
search is
performed.
z The mouse is unable to be detected.
→ Press the CONNECT button located on
the bottom of the mouse, and then try the
search again.
z The power switch on the mouse is set to OFF.
→ Check the power switch setting on the
bottom of the mouse.
z The Bluetooth function on your computer is
not activated.
z Make sure that the Bluetooth function is
activated.
→For details, refer to the manuals provided
with your personal computer.
I am asked to input
a key at the time of
authentication.
Input “0000” as the key.
To prevent fire or shock hazard, do not expose the unit to rain or
moisture.
WARNING
Owner’s Record
The model number and the serial number are located inside the battery
compartment of the mouse. Record the serial number in the space provided
below. Refer to this number whenever you call your Sony dealer regarding this
product.
Model No. VGP-BMS77
Serial No. ____________________
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.