User's Manual

Pairing introduction
The Bluetooth connection indication and LED indication is defined as below:
A dual-color, blue and white, LED is used to indicate the status of power and Bluetooth connection, present
DPI, including the power on and off state, low-power alert, Bluetooth pairing, Bluetooth reconnecting.
The power detection is defined as three levels:
A: Power is sufficient: voltage level is higher than 2.2 volt; LED will be on in the color upon present DPI
setting, and then be off in 2 seconds.
B: power is low: voltage level is lower than 2.2 volt, but higher than 2.05 volt; LED will be on in the color
upon present DPI setting, and then be blinking once every one second, lasting for 1 minute.
C: Power is off: voltage level is lower than 2.05 volt; mouse power is cut off and LED is not turned on
The Bluetooth connection indication is defined as below:
In pairing mode: blue LED starts blinking once every one second, lasting for 2 minutes. AS long as KIWI BT is
successfully paired with the computer, blue LED will be turned off.
KIWI checks the battery status and enables the LED indication:
A: battery status change in active mode
B: mouse is waked up from sleeping mode or standby mode
C: power is manually turned on and off by the sliding switch