User's Manual

CONFIDENTIAL
致伸科技股份有限公司
PRIMAX ELECTRONICS LTD.
BT Mono Headset BLS
Product Name: HTC BH M500
Document ID:
Version #: 0.2
Date: 2011/9/2
6 (10)
User Guide
Primax Electronics Ltd.
6
2. Charging the battery
Before using HTC BH M500, we advise that you charge the product for approximately
2 hours. When the battery is fully charged, it provides up to 6 hours of talk time and
up to 200 hours of standby time.
1. Connect the charger cable to HTC BH M500
2. Plug the AC adapter into a wall outlet. When HTC BH M500 is charging, Red light
is on.
3. When the battery is fully charged, the Red light is off and Green light is on.
3. Pairing the Bluetooth headset with a compatible phone
Pairing is the process of linking the headset with your Bluetooth enabled mobile
phone. After this process is completed, you can use the HTC BH M500 only with this
paired mobile phone. If you want to use HTC BH M500 with another mobile phone,
you must repeat the pairing process again. The HTC BH M500 can be paired with up
to 8 compatible phones but connected to only one phone at a time.
1. Make sure that the compatible phone is turned on and within 10 meters of the
headset.
2. Turn on HTC BH M500 and make sure the headset is charged. Press and hold
MFB for about 4 seconds. The Green LED will flash rapidly. Release the button and
the headset is now in pairing mode.
3. Activate the Bluetooth connection from the phone. You may need to consult with
user guide of your phone regarding how to do that.
4. Set the phone to start searching for Bluetooth devices as instructed in user guide
of your phone.
5. Select the device name HTC BH M500 from the list displayed on the phone.
6. Enter the pin code 0000 to connect (or “pair”) HTC BH M500 to the phone.
7. Start using the headset.
4. Disconnecting the Bluetooth headset from the phone
To disconnect HTC BH M500 from the phone, do one of the following: