User Manual

Charge the headset
Before using the headset for the first time, you must charge it for approximately 3.5 hours.
When the battery is fully charged, it provides up to 12 hours of talk time, 10 hours of music
playing time and up to 350 hours of standby time. Always use the charger provided in the sales
package.
1. Connect the charger cable to the headset.
2. Plug the charger into a wall socket. The lights turn to solid red in charging status.
3. When the battery is fully charged, the red light will turn off.
Turn on / off the headset
To turn on the headset
Press the Multifunction button for more than 3 seconds. You will hear a long high tone beep
from the earpiece and see blue light on right earpiece flashing three times rapidly.
To turn off the headset
Press and hold the Multifunction button. You will hear a long high tone beep from the earpiece
and see solid red light on for 3 seconds on right earpiece.
Pair the PSH-1A headset and your mobile phone or other devices
You will need to pair your PSH-1A with Bluetooth-enabled mobile phone and/or devices before
you can use it. Your PSH-1A can be paired with up to 8 compatible phones/devices. However,
it can only be connected to one phone at a time.
To pair the headset…
1. Make sure the headset is off. Press and hold the Multifunction button for more than 7
seconds, until you short low tone beeps from the earpiece and the blue and red lights
flashing alternately.
2. Refer to user guide of the phone / device and set the phone / device into pairing mode.
3. When the phone / device finds the headset, PSH-1A will be shown. Please accept and
confirm with the presskey 0000 (4 zeros).
4. Once pair and connection are succeeded, you will hear a short high tone beep and
see blue light flashing. The headset is now ready to serve.
The PSH-1A will automatically reconnect to the last-connected phone / device. If the
connection is failed due to phone / device not found, the headset will automatically enter into
pairing mode.