User Manual

Place the headset over your ear
The headset is ready to wear on either ear. You can plug the earpiece
into your ear and point the headset toward your mouth.
The headset comes with a 15 mm earbud by default. For a better fit on
your ear, the headset is provided with an extra learger earbud (18 mm).
You can use the larger one if necessary.
Hardware reset
Plug in power connector (DC jack). Please notice that pairing information
will NOT be erased.
Operation
To turn on the headset
Press the multi-function key for about 2 seconds. The LED lights in solid green
for 1 second. 4 ascending tones can be heard.
To turn off the headset
Press the multi-function key for about 4 seconds. The LED lights in solid green
for 1 second. 4 descending tones can be heard.
Making a Phone Call
When the headset is connected to the phone, make a call using the phone in
the normal way.
Note: the call functions depending on the phone type you use. Please refer to
the manual of your phone for the related function.
Other status
Answering and Ending a Phone Call
When a call comes in, the LED will flash twice briefly every second, and
ringing tones can be heard through the headset until the call is answered.
Press the multi-function key briefly to answer the call. Press the multi-
function key briefly to end an active call.
You can also answer and end the call through the mobile phone.
Note: Some phones offer Auto Answer function and may be used with the
headset or speakerphone, but this is a phone dependent feature. Please
refer to the manual of your phone for that function.
Rejecting a Call
When you receive an incoming call that you do not want to answer, press
the multi-function key for more than 2 seconds.
Redialing the Last Dialed Number
(Phone dependent)
Double press the multi-function key for when no call is in progress. A
high tone can be heard.
Switching the Call between Phone and Headset
Press the multi-function key for 2 seconds or use the respective function in
your phone. A high tone can be heard.
Voice dialing (phone dependent)
Press the multi-function key briefly when there is no call in active to initial
voice dialing, and one high tone can be heard. To terminate voice dialing,
press the multi-function key briefly again.
Reconnecting the Paired Bluetooth Headset to a
Compatible Phone
To reconnect the Bluetooth Headset to the last connected phone, proceed
as follows:
1. Press and hold the multi-function key for 4 seconds to turn on the
Bluetooth Headset.
2. Make sure your phone is on and Bluetooth function is enabled. Please
refer to the phone’s user guide and make the connection in the
Bluetooth menu of your phone.
3. The phone should connect to the headset automatically. If not, please
refer to ‘Pairing the Bluetooth Headset with a Compatible Phone’
section and performance pairing again,
Note: If the headset is away from the connected phone for more than 10
meters, the headset will be disconnected from the phone, and will perform
reconnecting procedure automatically within 10 minutes.
Status LED
Sound
Idle* (power on but
not connected)
Battery low
Charging
Call in active
Solid light
A low beep every
5 seconds
n/a
n/a
n/a
Flashing once every 2.5 seconds
Double brief flashing every 2.5
seconds
Double brief flashing every 5
seconds
* The headset will switch off automatically if in idle mode for 30 minutes.