User Manual

Wireless Mouse Installation
Your Wireless Mouse installation is fast and easy. It can be completed in 3 simple steps. Note: After installing the driver software on your
computer you will need to shut down and reboot your system. Make sure that all work is saved and all programs are closed before installing this device.
Step 1 - Battery Installation:
1. Locate the two AAA sized 1.5 Volt batteries that came in your Wireless Mouse package.
2. Remove the battery cover from the compartment at the back of your Wireless Mouse.
3. Install the two batteries into the compartment paying close attention to proper polarities.
4. Replace the battery compartment cover.
Step 2 - Connecting the Receiver:
PS/2 Installation
1. Make sure your computer is turned off.
2. Locate the round 6-pin (PS/2) connector at the end of receiver cable.
3. Connect this to an available round 6-pin (PS/2) port at the back of your computer.
4. Turn your computer on.
USB Installation (Note: If you have Microsoft Windows 95 or Windows NT Workstation, these operating systems do not support USB.)
1. Make sure that your computer is turned on.
2. Remove the USB to PS/2 adapter at the base of the cord and locate a rectangular USB port on your computer or USB hub.
3. Plug the USB (rectangular) connector into the USB port and follow the on-screen instructions.
Step 3 - Software Installation:
Included in your package is a CD-ROM containing driver software for the Wireless Mouse. Note: If you are installing this device running Windows 2000 or Windows XP, you may
encounter a message stating “Digital Signature Not Found” or this device has not passed the Windows XP logo testing. Select
Yes
to continue the installation running Windows 2000
or click
Continue Anyway
to complete the installation running Windows XP.
1. Insert the Mouse Suite CD-ROM into your CD-ROM drive and then follow the setup program instructions on your screen. Note: If the setup program does not appear, please refer to
steps 2-5 listed below.
2. Click the Start button at the left hand corner of the computer screen.
3. Click Run. Type <drive>:\setup. For example, if your CD-ROM drive letter is (E:), type e:\setup.
4. Click OK.
5. Follow the onscreen instructions to complete the Mouse Suite software installation.
Once the Mouse Suite software installation is completed, you can start using your Wireless Mouse.
Welcome! 1-1
1-2 Optical Wireless Mouse Installation
Wireless Mouse Installation 1-2