User's Manual

Please Note: Please set Record ON/OFF switch to OFF after recorded your message.

Please Note:

Operators need to understand that the quality of the recordings, the contents of the

information provided and the locations of installation of the base units are critical to the

successful use of the STEP-HEAR™ system.

1. Record messages in a quiet environment with no background noise or sound.

2. Carefully decide on number of strategic installation points of the base units at chosen

areas.

3. The provided recording messages need to be relevant and suitable to the area

regardless of which direction one may approach, especially if directionality is

provided. Make sure that when offering direction message, there is no alternative

for it to avoid direction confusion if one travels in opposite side. Do not use: “left”,

“right” but announce the name of the location: “elevator”, restrooms” etc.

Please Note: Base units should be installed at least 10 meters apart from each other.

Volume control

Adjust the volume to a more comfortable listening level by sliding the VOLUME switch (8)

on the side of base unit.

Setting the remote range (5)

The operating range can be set by the Range Medium/Long switch. When you set the

switch to Medium position, the operating range is about 3 to 8 meters. When you set the

switch to Long position, the remote range is about 3 to 10 meters. The activator will

vibrate and beep automatically once in the range of the base unit.

Please note: The ranges quoted are for indication only and will vary according to local

conditions and environment.

Activator

Turn the activator On/Off

To turn the activator ON, press and hold the POWER key (14) on the activator for 2-4

seconds until a beep tone is heard. To turn the activator OFF, press and hold the POWER

key again, 2-4 seconds until two beep tones are heard. The red LED indicator (13) will

flash.

Activator default set is beep & vibrate on.

Turn the beep tone OFF