User's Manual

2
Base Unit
Connecting the AC Adaptor of the Base Unit
1. Plug the power cord of the AC adaptor into the jack labeled DC 9V on the back of the
Unit (1).
2. Plug the other end of the power cord into an electric outlet.
Fitting the batteries
1. The battery compartment is to be found on the underside of base unit.
2. Open the battery compartment with a small screwdriver or a pointed object.
3. Insert 4 AAA 1.5V batteries. In doing so, ensure that the polarity is correct.
4. Close the battery compartment.
The battery can be lasted up to 8 hours while mains power failure. Batteries should be
used only for backup. The batteries should be changed when the red LED lights (4). All
four batteries must then be replaced.
Wall mounting
Your unit is suitable for wall mounting. Use two screws for fixing. Drill two holes vertically
one above the other, 72mm apart, and leave the screws protruding from the wall by 5mm.
Now place the unit over the screws and push it slightly downwards.
Recording message
1. Set the Record ON/OFF switch (2) on the base unit to ON, press and hold ANN1 (7) or
ANN2 (9).
2. Speak clearly when you hear a beep tone, the message can be up to 1 minute long.
3. Release the ANN1 or ANN2 button, the base unit will play the recorded message
automatically. You can press ANN1 or ANN2 button at any time to listen the message.