User's Manual

6
INSTALLATION
Where to install this feature-oriented telephone
When installing this feature-oriented telephone, consider that the unit should be placed in an area of
common use during the day and night time.
ClearVoice 200™ users should locate the phone within 10-15 feet line of sight from where user spends
a lot of time. The remote pick-up can be from a distance far greater than the 10-15 feet. This allows
users the remote speakerphone features of the unit plus remote activation of the Emergency Help
System™, for those who may not easily get to the telephone or are concerned with falling.
ClearVoice 100™ users should locate the phone within 10-15 feet from where they spend a lot of time.
This allows them to use the remote speakerphone features of the unit. ClearVoice 100™ users can
purchase the remote activation of the Telemergency Emergency Help System by calling the consumer
helpline @ 1-888 558-7420.
ClearVoice 50™ can purchase an optional accessory to include the remote features of each these units
remotely by calling the Consumer Helpline 1 888 558 7420.
Installing batteries
Your telephone requires four AA batteries (not supplied) if you wish to utilize all features during power
failures. During power failures, full functionality of the telephone is maintained for a total of a maximum
of 12 hours total power failure time. If you do not have batteries installed the basic phone function of
calling out and receiving a call can still be used.
Note: The telephone numbers in memory and the voice recordings are stored in non-volatile flash
memory which do not require battery backup.
Before opening the battery compartment, make sure the telephone is disconnected from the telephone
line and the 120V AC Adaptor is disconnected from the unit.
1. Use a flat-blade screwdriver to lift the battery compartment door.
2. Insert four AA alkaline batteries into the compartment as indicated by the polarity symbols.
3. Snap the battery compartment door back into place.
Note: If appears on the display or the display dims, replace the batteries with 4 new alkaline AA
batteries to assure maximum power failure time.
To replace the battery of the remote pendant: ClearVoice 100™ and ClearVoice
200™
The pendant is equipped with a pre-installed internal battery.
1. Use a screwdriver to remove the screw on the lower case of the pendant and remove the lower case.
2. Replace the 12V DC Alkaline battery with a fresh one.
3. Replace the lower case and secure it with the screw.
4. It is important that full functionality be checked out after replacing battery.