User's Manual

3. When the red key on the optional pendant (standard on the ClearVoice 200™) is pressed and held

for 3-5 seconds, the LED on the pendant will begin flashing and if the pendant is pressed for 8

seconds the LED will simply stay ON for approximately five (5) seconds letting user know that the

Emergency Help System has been turned off and reset.

To activate the Emergency Help system is simple. Simply press and hold down red button until LED

flashes on the pendant. Then release button. This LED will stay lit for 15 seconds.

4. To stop the already activated emergency help system, turn off speakerphone by pressing the

speakerphone button or if using the dual pendant (CV112). Press the red button on pendant for for

more than 8 seconds. LED will stop flashing and remain on for approximately 5 seconds

5. If a called party presses 0 after hearing the emergency message, the emergency speakerphone

feature will be activated allowing the called party to speak to the caller, and the caller can respond (if

able) for up to 1 minute if in the speakerphone of the ClearVoice 200. After minute, beeps will be

heard for 7 seconds and to continue either party can press any key on their numeric keypad for the

call to continue for another minute.

6. The emergency help system will automatically stop dialing the entered emergency numbers if

all the emergency nos. have been dialed or if any person who has received the emergency call

presses 1 then 2 on their tone dialing phones numeric keypad after the 0 key has been pressed.

7. Do not pick up handset of ClearVoice 200 if the Emergency Help System has been activated, the

speakerphone is active. Lifting the handset will deactivate the Emergency Help System.

8. There is an optional CV112 dual pendant that can be purchased for the ClearVoice 50 or 100 models

(standard on the ClearVoice 200™). This feature is important for those who are concerned with

falling or are concerned that they can’t get to the telephone in an emergency. For more information..

call our Consumer Helpline 1-888-558-7420.

Checking the Range of the Dual Wireless Help Pendant (CV112)

Note: The typical range can operate up to 100 feet line of sight. This range may be reduced by structural

or environmental conditions.

Follow all installation instructions. Before checking the range remove the telephone line cord where it is

marked TEL.LINE located at the back of the unit.

Press and hold the red button on the pendant until the LED on pendant begins flashing (from the

farthest place you will be using the pendant within the above criteria). If within range, The Emergency

Help System will be activated and you will hear the local alarm from unit. To stop the unit from dialing

emergency numbers.

Press and hold the red button for 8 seconds until the LED stops flashing and remains steady ON for

approximately 5 seconds. The CV112 pendant should be used at a reduced range .

Note: If you are out of range of the unit, move closer and follow the directions.

IMPORTANT: Install the telephone line cord to where it is marked TEL.LINE located at the back of the

unit.

To verify you reconnected the telephone line cord.. press speakerphone button until you hear dial tone,

then press speakerphone button again to turn off.