User's Manual

To activate the Emergency Help System:

IMPORTANT: For the Emergency Help System to activate and also dial out the emergency telephone

numbers entered in the desired sequence, as entered, requires that the telephone line ClearVoice 50,

100, or 200 is connected to is ON HOOK(hung up), and all instructions in setting up this important

feature have been cofirmed.

1. Press and hold the button on the telephone is pressed for 3 seconds, the NEW CALL LED on the

telephone will blink for 15 seconds. The telephone local alarm sounds for 15 seconds. The telephone

will then dial out the entered emergency help system numbers automatically in speakerphone mode.

Using the dual wireless pendandant (CV112).If you are activating the Emergency Help System with

the dual pendant (CV112) press and hold down the red button on the pendant for 3 seconds until the

pendant LED will begin flashing. The pendant will flash for approximately 15 seconds. This will

activate the Emergency Help System if user is within the operating range of the unit. Note: If user

holds the red pendant button for 8 seconds or more and is in the operating range of the unit, the

Emergency Help System wll turn off and reset. The LED on pendant should stop flashing and its LED

to remain lit for approximately 5 seconds. User must be in operating range of unit.

Note: To turn off the Emergency Help System if activated, simply press the Speakerphone button.

and note that the speakerphone LED will turn off or pick up handset of unit to turn off Emergency

Help System and speak to called party, if on the line. Then hang up telephone (ON HOOK) to reset.

Important: If during this local alarm period or at any other time the Emergency Help System is on, of

the emergency procedure simply press the speakerphone button You will note that the LED button in

the speakerphone button will turn off. You may also stop the emergency process by simply turning off

the Emergency Help System by picking up the handset of the ClearVoice 200

2. The telephone dials out the first emergency number (stored in the phone book emergency (location

1) in speakerphone mode, and then begins playing the emergency message .

If during the 60 seconds the emergency message is played and if available to the called party (

telephone number, and they acknowledge the call by pressing 0, the telephone will be put in

speakerphone conversation for 1 minute. After 1 minute, the phone beeps loudly for 7 seconds.If

within these 7 seconds, the called party presses any key on the phone, the unit will be kept in

speakerphone mode conversation for an additional 1 minute continuously without stopping. If any

numeric key on the phone is not pressed during 7 seconds, the call to the called party is disconnected.

Note: If 0 is not pressed during the 60 seconds message is played, the next emergency number in the

sequence to be called, will be dialled automatically in speakerphone mode.

Important Information about ClearVoice Emergency Help System:

1. If NO emergency numbers have been entered, the telephone will not dial any no. and just beep loudly

for 15 seconds continuously when the emergency ( ) button on the telephone, is pressed and and

held for more than 3 seconds or on the red button on CV112 dual pendant (standard on the ClearVoice

200™) is pressed for 3 seconds. If red pendant button is pressed and held for 8 seconds or more

continuously, the emergency process will stop and reset and reset

2. It is important that the CV 112 pendant must be within the range of the telephone to activate the

emergency feature.