User's Manual

20
To dial and check a displayed emergency telephone number from the Phone
Book Memory:
1. With the required display telephone number showing with the icon on the LCD on the display,
press OK button, press OK button again. The telephone dials out the displayed telephone number
automatically in speakerphone mode.
2. The display shows dialed out telephone number and counting timer.
OR
1. Pick up the handset or press SPEAKER button (the speaker LED will light) and wait for a dial tone.
2. Press and release button, icon is shown.
3. Review the stored icon on the LCD phone number by pressing or
4. Press OK button, press OK button again
5. If you desire you can speak to called party and explain that you are adding their telephone number to
your Telemergency Emergency Help System.
IMPORTANT: Follow all Cautions below if Emergency Help System is to be activated. If you are using
the Emergency Help System and wish to call “911” or other emergency services which have a dispatcher,
the following procedures should be followed. Note: Check with your local “911” and/or other emergency
services and verify the use of their no. in your area.
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO
EMERGENCY NUMBERS:
1. Remain on the line and briefly explain to the dispatcher the reason for the call.
2. Perform such activities in the off-peak hours, such as early morning or late evenings.
Caution - To ensure proper operation, this equipment must be installed according to the enclosed
installation instructions. To verify that the equipment is operating properly and can successfully report
an alarm, this equipment must be tested immediately after installation, and periodically thereafter,
according to the enclosed test instructions.
Caution - This equipment cannot report an alarm when other equipment (telephone, answering system,
computer modem, etc.) connected to the same phone line is in use.
Recording / Editing / Deleting voice prompt of name of phone book
With caller ID service activated, when an incoming call is received, the unit will display and announce
the caller’s phone number. If the caller’s phone number is stored in the phone book, and caller’s name
will be displayed too.
If the voice prompt is recorded for this phone number, the unit will announce the voice prompt recorded
instead of the caller’s phone number.
1. Press and release the MENU button until the “NAME RECORDING” is shown.
2. Press the OK button. A list of the phone book entries will be display.
3. Press or to select the list you like to record a voice or name for it.
4. To record or edit the voice prompt, hold down OK button. Speak clearly into the microphone after a
beep and “VOICE” icon is flashing. Release the button when you finished or the unit will stop recording
after 3 seconds. The new voice prompt will then be played automatically.
To delete the voice prompt recorded, press DELETE button during the voice prompt is playing.
5. Repeat step 3 to 4 to edit or delete more entry or exit the set-up mode by pressing the button.