User's Manual

USING THE TELEPHONE

Dialling a Call

1. Pick up the handset or press SPEAKER button (the speaker LED will light) and wait for a dial tone.

2. Press the keypad for the telephone numbers you wish to dial. The display will show the number that

you dialed on the keypad. If you dial a number over 14 digits long, it will show the last 14 digits only.

3. When you have completed your call, hang up the handset, or press SPEAKER button again.

It is possible to switch from a handset conversation to a speakerphone conversation pressing the

SPEAKER button and picking up or hanging up the handset accordingly.

Pre Dialing a Call

1. Dial on the keypad the telephone number. The telephone will voice the digits dialed (with voice option

ON). To correct a number press the DELETE button for each incorrect digit

2. Pick up the handset or press SPEAKER button

Receiving a Call

When you receive a call, the telephone rings, the Ringer LED flashes and the display shows the CALL#

and the caller telephone number, and will state the name of the caller if the number matches with a

name recorded in the phone book, if not, it will say the numbers of the calling party if available (Caller ID

service required)

This feature allows you to decide to pick up the phone or not depending on who is calling.

If you want to talk to the caller:

1. Pick up the handset or press SPEAKER button to answer the call.

2. At the end of the call, return the handset to the cradle or press SPEAKER button again to disconnect..

Receiving a Call/Speakerphone remotely (Models 100 and 200)

Picking up the handset will allow conversation to continue.

simply press the red button on the CV111 or CV112 pendant for 1 second to connect the call and

activate its speakerphone if you hear the phone, but can’t get to the telephone.

When you are near the speakerphone you can begin speaking to the caller without picking up the

handset.

To terminate the call, press the red button again for 1 second.

Note: A feature is include in this telephone to help protect you if you activated the speakerphone remotely

(wireless pendant), and forgot to disconnect the phone. In this way, the speakerphone can turn OFF.

After 15 minutes, the phone will beep for 7 seconds. If within these 7 seconds the called party presses

any numeric key on the phone, the unit will be kept in speakerphone mode conversation for 1 minute

continuously. If no numeric key on the phone is pressed during the 7 seconds, the telephone will deactivate

the speakerphone and return to standby mode unless you pick up your handset on the ClearVoice 100

or 200.

This convenience feature is particularly useful if you are sitting on a couch, busy doing something else,

can’t get to the phone on time and don’t want to miss the call.