User's Manual

Please read this section prior to using the important features of your ClearVoice

50,100 or 200.

Symbols you should know:

OK is also used for CALL BACK

MENUis also used for EDIT

CLIP is also used for EXIT

SETTING UP TO USE ALL THE FEATURES OF YOUR UNIT

Note: Your unit has many VOICE PROMPTS to assist you

The following features can use Voice Prompts or prompts on the LCD display on your unit

Setting the LCD contrast

Setting the Time and Date

Settings for Tone /Pulse operation- preset to tone

Setting the Ringer Melody (select the type of sound of the Ringer)

Setting the language (English or Spanish)-preset to English

Setting the Voice ON/OFF (preset to Voice)

Ringer Volume Control

Handset Volume Control

Lets get started:

Important: In setting the following criteria, if there is a delay in programming a specific feature of more

than 60 seconds, your unit will reset. In that event please re-enter the section you are entering.

Setting the language

Note: This unit has a voice menu as well as a prerecorded emergency message that can display and/or

speak its messages in English or Spanish. Your unit is set to English. Skip this section if you wish to

continue usage in English by pressing EXIT button.

This telephone is able to write on the LCD and to give you a voice guide in two different languages. By

selecting the language the user will automatically select both the voice and the written LCD language.

1. Press and release the MENU button until LANGUAGE is shown.

2. Press the OK button, the display shows ENGLISH (for example)

3. Select the desired language using the or and confirm with OK button. Unit will say Language.

4. Press (Exit) button to exit this set-up mode.

Setting the LCD contrast (If LCD contrast is OK, press Exit button)

Depending on the viewing angle of the telephone, the user may want to adjust the LCD contrast:

1. Press and release the MENU button. The display shows LCD CONTRAST.

2. Press the OK button (located upper front left. The display shows the current contrast setting with

values between 1 and 5.

3. Press or (upper front right) and scroll until desired contrast to select the contrast level confirm

with OK button again. Unit will say TIME/DATE

4. Press (Exit) button to exit this set-up mode.