Owner's Manual

PRE35 Prisma Preamplifier User Guide
8
4 Connect the antennae
Connect the two antennae supplied with the PRE35 to
the ANT 1 and ANT 2 sockets on the back panel, and
position the two antennae at a slight angle from the
vertical.
One antenna is for Bluetooth connectivity, and the other
one is for Wi-Fi connectivity.
5 Connect power
Plug one end of the mains cable supplied with the
PRE35 into the power connector on the back panel,
and connect the other end to a wall socket.
If this cable is not suitable for your power outlets please
contact your supplier for an alternative cable.
Note: See Phase , page 19, for information about getting
the best sound from your PRE35.

WARNING: Always disconnect the PRE35
from the mains power before connecting or
disconnecting any cables.
Switch on the PRE35, using the switch on the back
panel.
To switch on from standby
Press O on the front panel or remote control.
The display shows:
PRIMARE
l
l
l
l
6 Connect to a network
For best results we recommend connecting via cable.
To connect via an Ethernet cable
Connect an Ethernet cable between your router and the
LAN socket on the back panel of the PRE35.
When the PRE35 is ready to set up the network the
display will show:
Configure network
Install the free Google Home app on your mobile
device.
Run Google Home.
It will display New device found, PRE35.
Click SET UP and follow the instructions.
After playing a test sound you will be prompted to select a
name for your PRE35.
You will now be able to stream music to your PRE35.
To disconnect from the Ethernet network
Remove the Ethernet cable.
l
l
l
l
l
To connect via Wi-Fi
When the PRE35 is ready to set up the network the
display will show:
Setup mode
Make sure Bluetooth and Wi-Fi are enabled on your
mobile device.
Install the free Google Home app on your mobile device.
Run Google Home.
It will display New device found, PRE35.
Click SET UP and follow the instructions.
After playing a test sound you will be prompted to
connect to your home Wi-Fi network.
Select your Wi-Fi network and enter the password.
You will now be able to stream music to your PRE35.
To disconnect from the Wi-Fi network
Either:
Select Wi-Fi settings for the PRE35 in the Google Home
app.
Select Forget this network.
Or:
Reset the PRE35 to its factory defaults; see Factory
reset, page 19.
l
l
l
l
l
l
l
l