Install Instructions

4515 E. 139th Street Grandview, MO 64030 | [phone] | PRIER.com
Installation Instructions for PRIER
P-118 Hot & Cold Wall Hydrant
Please leave this sheet for the property homeowner
OPERATION
MAINTENANCE
Operation of the P-118 Freezeless Hot/Cold Wall Hydrant is a simple process. Water ows through the hydrant when the
larger handle is turned counter-clockwise. Turn off the hydrant by turning the handle clockwise to the ‘OFF’ position.
The hydrant will drain for a few moments. If the dripping persists after 30 seconds, tighten the handle slightly until the
dripping stops. Be careful not to overtighten the hydrant.
To adjust the temperature of the water, simply turn the smaller temperature selector handle to the desired position as
indicated on the handle. All the way to the left (9 o’clock) is hot, in the middle (12 o’clock) is warm, and all the way to the
right (3 o’clock) is cold. The temperature selector handle can be set at any position between the 9 and 3 o’clock position
to reach the desired temperature.
This ASSE 1019 device is intended for irrigation use and outdoor watering and shall not be subjected to more than 12
hours of continuous water pressure.
ALWAYS REMOVE HOSE DURING FREEZING TEMPERATURES
The PRIER P-118 Hot/Cold Wall Hydrant leaves the factory fully tested and operational. It is treated with an FDA ap-
proved lubricant where needed. The hydrant requires no scheduled maintenance to provide long life. If a problem does
arise, all the serviceable components are offered in repair kits. The hydrant can be fully serviced from the exterior of the
structure so there is no need to maintain access from the inside.