Owner`s manual

34
www.pridemobility.com Cyclone/RevB/Apr03
No tools are required to disassemble or assemble your Sport Scooter. Always disassemble or assemble your Sport
Scooter on a level, dry surface with sufficient room for you to work and move around your Sport Scooter. Keep in
mind that the disassembled sections of the Sport Scooter take up more floor space than the assembled Sport Scooter.
DISASSEMBLY
You can disassemble the Sport Scooter into seven pieces: The seat, the front section, the rear section, the rear
shroud, the basket, and the batteries. Place the Sport Scooter in an area where you have sufficient clearance to
move the parts around. You need about four or five feet in all directions. You may need assistance to lift some of the
Sport Scooter components. See IV. Specifications for individual component weights.
Before beginning disassembly, place the manual freewheel lever in the drive (down) position. Also, coil the charger
power cord and store it in the rear storage compartment. See figure 8.
I X . DISASSEMBLY AND ASSEMBLY
Figure 18. Seat Removal
Figure 19. Rear Shroud Removal
CAUTION! Failure to unplug both battery harnesses and the front-to-rear harness prior to
disassembly could result in permanent damage to the Sport Scooter.
WARNING! Lifting weight beyond your physical capability may result in personal injury.
Ask for assistance when necessary while disassembling or assembling your Sport Scooter.
1. Pull up on the seat lock lever to unlock the seat. Rotate the seat one-eighth of a turn, and lift the seat up and
off the Sport Scooter. See figure 18.
2. Gently lift the rear shroud off of the Sport Scooter. See figure 19.
3. Disconnect the battery tie-down straps (if so equipped).
4. Unplug both black and white 2-pin battery harnesses. See figure 20.
5. Unplug the front-to-rear harness that connects the control console assembly to the electronics module. See
figure 21.
6. Lift both batteries from the Sport Scooter. See figure 22.
7. Push the locking cam levers forward and remove the ball detent pins. See figures 23 and 24.
8. Gently slide the two sections of the Sport Scooter apart. See figure 25.
9. Grab the handle grip on the tiller, pull upward on the tiller adjustment lever, and gently lower the tiller down to
the Sport Scooter chassis.
NOTE: There is no need to disconnect the motor harness when disassembling the Sport Scooter. See figure 26.