Owner`s manual

32 Legend
No tools are required to disassemble or assemble your Legend. Always disassemble or assemble your Legend on
a level, dry surface with sufficient room for you to work and move around your scooter. Keep in mind that the
disassembled sections of the Legend take up more floor space than the assembled Legend.
DISASSEMBLY
You can disassemble the Legend into seven pieces: the seat, the front section, the rear section, the rear shroud, the
basket, and the batteries. Place the scooter in an area where you have sufficient clearance to move the parts
around. You need about four or five feet in all directions. You may need assistance to lift some of the scooter
components. See IV. Specifications for individual component weights.
1. Place the manual freewheel lever in the drive (down) position.
2. Coil the charger cord and store it in the rear storage compartment. See figure 8.
3. Gently lift the seat up and off of the Legend. See figure 18.
4. Gently lift the rear shroud off of the Legend. See figure 19.
5. Disconnect the battery tie-down straps (if so equipped).
6. Unplug both black and white 2-pin battery harnesses. See figure 20.
7. Unplug the silver front-to-rear harness that connects the control console assembly to the rear electronics
module. See figure 21.
8. Lift both batteries off the Legend. See figure 22.
I X . DISASSEMBLY AND ASSEMBLY
FIGURE 18. SEAT REMOVAL
FIGURE 19. SHROUD REMOVAL
CAUTION! Failure to unplug both battery harnesses and the front-to-rear harness prior to
disassembly could result in permanent damage to the Legend. Grab the handle grip on the tiller,
pull upward on the tiller adjustment lever, and gently lower the tiller down to the center of the
Legend chassis until it is fully lowered.
10. Push the locking levers forward and remove the ball detent pins. See figures 23 and 24.
11. Gently slide the two sections of the scooter apart. See figure 25.
Note: There is no need to disconnect the motor harness when disassembling the Legend.