Owner`s manual

21Legend
Status LED
The Status LED alerts you to electrical problems that may occur with the Legend. The LED remains constantly lit while
your scooter is on. If the Legend develops an electrical problem, the status LED will flash a code. See XI. Basic
Troubleshooting for troubleshooting flash codes.
REAR SECTION
The onboard battery charger (not shown), the charger power cord receptacle, the batteries (not shown), the electronics
module, the main circuit breaker (reset button), the ammeter, the manual freewheel lever, and the motor/transaxle assembly
are located on the rear section of your Legend. See figure 8. Refer to IX. Disassembly and Assembly for instructions on
removing the rear shroud.
ANTI-TIP WHEEL
MOTOR/TRANSAXLE
ASSEMBLY
MANUAL FREEWHEEL LEVER
AMMETER
MAIN CIRCUIT BREAKER
(RESET BUTTON)
REAR STORAGE COMPARTMENT
CHARGER POWER CORD RECEPTACLE
5-AMP
CHARGER
FUSE
REAR ELECTRONICS MODULE
SPARE FUSES
LIGHT
BULBS
REAR LIGHT
FUSES
3-AMP CONTROL CONSOLE ASSEMBLY FUSE
FIGURE 8. REAR SECTION (LIGHT COVERS REMOVED)
Batteries
The batteries store the electrical energy that powers your Legend. See VI. Batteries and Charging.
Main Circuit Breaker
When the voltage in your Legends batteries becomes low or your Legend is heavily strained because of excessive loads or
steep inclines, the main circuit breaker may trip to protect your Legends motor and electronics from damage. See figure 8.
n The main circuit breaker reset button pops out when the breaker trips.
n When the breaker trips, the entire electrical system of your Legend shuts down.
n Allow a minute or two for your Legends electronics to rest.
n Push in the reset button to reset the breaker.
n If the breaker trips frequently, you may need to charge your batteries more often. You may also need to have
your Pride provider perform a load test on your Legends batteries.
n If the main circuit breaker trips repeatedly, see your authorized Pride provider for service.
V. YOUR LEGEND