Owner`s manual
Maxima
29www.pridemobility.com
VIII. DISASSEMBLY AND ASSEMBLY
To disassemble the scooter:
1. Place the manual freewheel lever in the drive (down) position.
2. Lift the seat straight up and off the scooter. See figure 16.
3. Gently lift the rear shroud off of the scooter. See figure 17.
4. Disconnect the battery tie-down strap that holds the batteries in place.
5. Unplug both black and white 2-pin battery harnesses. See figure 18.
6. Unplug the front-to-rear harness from its mating plug. See figure 19.
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior to
frame separation could result in permanent damage to the scooter.
WARNING! Lifting weight beyond your physical capability may result in personal injury.
Ask for assistance when necessary while disassembling or assembling your scooter.
SEAT
REAR SHROUD
REAR SECTION
BATTERIES
BASKET
FRONT SECTION
Figure 15. The Scooter Disassembled
DISASSEMBLY
You can disassemble the scooter into seven pieces: the
seat, the front section, the rear section, the rear shroud,
the basket, and the batteries. See figure 15. No tools are
required to disassemble or assemble your scooter, but
keep in mind that the disassembled sections of the scooter
take up more floor space than the assembled unit. Always
disassemble or assemble your scooter on a level, dry
surface with sufficient room for you to work and move
around your scooter-about 2 meters (5 feet) in all
directions. Remember that some scooter components are
heavy and you may need assistance when lifting them.
Figure 19. Disconnecting The Front-To-Rear Harness
Figure 18. Disconnecting The Battery Harnesses
Figure 16. Seat Removal Figure 17. Rear Shroud Removal