Owner`s manual

20 www.quantumrehab.com Quantum Dynamo ATS/RevA/Apr04
IV. DISASSEMBLY AND ASSEMBLY
DISASSEMBLY
Your power chair disassembles into eight easily transportable component assemblies (seat and leg rests not shown)with
no tools required. See figure 12.
WARNING! Even though no tools are required to disassemble or assemble your power chair, you
should not place your hands or fingers on the areas of the component assemblies where they may
be pinched, as the assemblies snap together or snap apart.
NOTE: During both disassembly and assembly of your power chair, take your power chair out of
freewheel mode so that the chair does not roll while you are disassembling or assembling it. See
III. The Quantum Dynamo ATS.
Disassembly Preparation
Position your power chair in a location where there is ample working room on all four sides. We recommend at least one
metre of clearance on all sides. There are eight component assemblies, some of which take up a great deal of space when
disassembled from the chair.
WARNING! Make certain that your power chair is powered off and is not in freewheel mode.
Figure 12. Quantum Dynamo ATS Component Assemblies
RIGHT POWER BASE
FRAME ASSEMBLY
BATTERY BOXES
BATTERY WELL FRAME
FRONT FRAME
LEFT POWER
BASE FRAME
ASSEMBLY
To disconnect the joystick/controller harness:
Disconnect the joystick/controller harness from its connector on the electronics tray. See figure 6. You may need to pull
firmly and gently wiggle the harness to remove it from the connector.