Owner`s manual

Quantum Dynamo 1107 www.quantumrehab.com 43
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, remind-
ing you the batteries need to be charged immediately!
Power Accessories/Power Accessory Indicator (Optional)
If your power chair is equipped with power accessories such as a power tilt or power elevating leg rests, you can operate
them through the keypad. The power accessory indicator indicates the selected power accessory. Contact your Quantum
Rehab Specialist for more information.
Off-board Charger/Programming Socket
The off-board charger/programming socket is located on the front of the Remote Plus. If you use an off-board charger, the
charger current should not exceed 8 amps. Contact your Quantum Rehab Specialist for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket. See your Quantum Rehab Specialist for more information.
Controller Communications Cable
The controller communications cable provides the Remote Plus with a connection to the power module.
Sleep Mode
Your Remote Plus controller has a sleep mode feature. Sleep mode is a built-in circuit that automatically shuts off the main
power if the joystick is not moved in any direction for approximately five minutes. The battery condition meter lights on the
keypad indicate sleep mode by blinking once every five seconds. To restore power and continue, push the on/off key
twice.
Thermal Rollback
The Remote Plus is equipped with a thermal rollback circuit. This circuit monitors the temperature of the motors, power
module, and remote. In the event that any of them become excessively hot (above 122° F), motor voltage is reduced. For
every degree above 122° F, the voltage is reduced by 5 volts. This reduces your power chair’s speed and allows the
electrical components to cool down. When the temperature returns to a safe level, your power chair resumes its normal
speed.
VII. OPERATION
Remote Plus Error Codes
In addition to indicating the current state of battery charge, the battery condition meter can also indicate possible problems
with your power chair’s electrical system. If any of the battery condition meter lights are flashing rapidly, the controller may
be indicating an error. Error codes are displayed as a number of flashing lights. For instance, if the first light is flashing
rapidly, the battery voltage is nearly depleted. The following table identifies the individual error codes, probable causes,
and possible solutions. If you get one of these error codes, contact your Quantum Rehab Specialist.