Owner`s manual

Quantum Dynamo 1107 www.quantumrehab.com 27
V. COMFORT ADJUSTMENTS
Figure 18. Controller Mounting Block (FLIGHT Shown)
SETSCREWS
Figure 19. Swing-Away Footrests
ADJUSTMENT
SCREWS
FOOTREST
EXTENSION
SFR RELEASE LEVER
Controller Position
You can position the controller for either left-hand or right-
hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the seat
frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller. See VII. “Operation.”
2. Disconnect the controller from the power base.
3. Cut any wire ties securing controller cable to the armrest.
4. Loosen the mounting screws. See figure 18.
5. Remove the mounting block from the armrest.
6. Place the mounting block on the other armrest and tighten
the mounting screws.
7. Use a wire tie(s) to secure the controller cable to the armrest.
8. Plug the controller into the power base. See figure 6.
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the foot-
rests to the side before you transfer onto or off of your power
chair.
To rotate the SFRs:
1. Push in the release lever. See figure 19.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the two adjustment screws from the back of each
footrest extension. See figure 19.
2. Slide the footrest up or down to the desired length.
3. Reinstall the two adjustment screws.
Elevating Leg Rests
Elevating Leg Rests (ELRs) offer an infinite range of ad-
justment for the leg angle and a footrest adjustment range
of 12–19 in.
To rotate the ELRs:
1. Push in release lever A. See figure 20.
2. Rotate the ELRs.
MOUNTING SCREWS
MOUNTING BLOCK
ARMREST
ADJUSTMENT
SCREWS
Figure 20. Elevating Leg Rests
LEG REST
EXTENSION
RELEASE LEVER B
RELEASE LEVER A
To adjust the ELR length:
1. Remove the two adjustment screws from the back of each leg
rest extension. See figure 20.
2. Slide the leg rest up or down to the desired length.
3. Reinstall the two adjustment screws.