Owner`s manual

26 www.quantumrehab.com Quantum Dynamo 1107
Figure 16. Underside of Foot Platform
SETSCREW
V. COMFORT ADJUSTMENTS
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different heights
in 1/2-in. increments.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot platform
bracket. See figure 15.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot platform
bracket. See figure 15.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the quick release fasteners into the foot platform
bracket and tighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
See figure 16.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew.
2. Turn the setscrew clockwise to raise the front of the foot
platform.
3. Turn the setscrew counterclockwise to lower the front
of the foot platform.
Quick Release Fasteners
The foot platform is attached to the power base with two
quick release fasteners. Each quick release fastener con-
sists of a bolt, a lever, and a nut. See figure 17. The lever
has a cam on the end that allows it to clamp into place. The
quick release fastener has two states: clamped and
unclamped. When the lever is open, the quick release fas-
tener is unclamped. When the lever is closed, the quick
release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-
quarter or one-half turn.
Figure 15. Foot Platform Adjustment
FOOT
PLATFORM
BRACKET
QUICK RELEASE
FASTENERS
Figure 17. Quick Release Fasteners
LEVER (OPEN)
UNCLAMPED
NUT
CAM
LEVER (FULLY CLOSED)
CLAMPED
BOLT