User manual

PRG SERIES 400
®
ETHERNET SWITCH USER MANUAL 7
INSTALLATION
Installing Ethernet Switch
A Series 400 Ethernet Switch can be used independently or installed directly in a Series 400 rack chassis, using any
blank space above the LED Meter Module.
To install in Series 400 rack:
Step 1. Install Ethernet Switch as required in top portion of rack chassis (Figure 7).
Step 2. At Ethernet Switch rear panel, connect AC Line Cord 208V PowerCon® Cable (supplied) to Neutrik®
connector.
Step 3. After power is applied, verify that ON indicator is lit.
Step 4. At front panel, connect data cables as required. Refer to "Connecting Ethernet Switch to System" on
page 8.
Figure 7: Series 400 Rack
3U of rack space for
adding additional signal
processing devices.
EXAMPLE CONFIGURATION
S400 Rack Components May Vary
SERIES 400 RACK CHASSIS
LED Meter Module