User manual

54 PRG SERIES 400
®
POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL
Breaker Module Filter
Parts:
40.7154.0001.0 FILTER, FAN
Tools:
Screwdriver
WARNING: Remove power from rack before performing any maintenance procedures.
To clean a Breaker Module air filter:
Step 1. Disconnect power to rack.
Step 2. If required, remove Breaker Module from rack. Refer to "Swapping a Breaker Module" on page 55.
Step 3. Using screwdriver, remove filter as shown.
Step 4. Clean filter with soap and water. Dry thoroughly.
Step 5. Re-install filter.
Figure 4-3: Removing Breaker Module Air Filter
Note: The Breaker Module fan is triggered thermostatically and will only turn on if the ambient temperature inside the
chassis is too high.
Filter
15A 208V MODEL SHOWN
Rack Components May Vary