Manual

PRG NODE PLUS USER MANUAL 17
Virtuoso Mode
When the Node Plus is connected to a Virtuoso series console, the menu system will provide "Virtuoso" screens
which can be used to set up and monitor the Virtuoso system.
Note: The PRG Node Plus unit can only be used with Virtuoso consoles running software version 5.6 or greater.
Virtuoso Node Screen
The Virtuoso Node screen displays the thumbwheel address and mapped
DMX512 universes (as patched from the console). In the sample image at
the right, this unit has been set to thumbwheel 001, and Virtuoso
universes A-D have been patched to outputs 000 through 003 of this
Node.
To edit the thumbwheel address, press the joystick. The first digit will be
highlighted. Use up/down to change the digit, left/right to move to
another digit, and press down to save and exit.
Network Stats
The Network Stats screen displays transmit and receive statistics since
power-up.
This screen is not editable.
TX #: successful transmits fail: transmit failures
T/O: transmit time-outs HwEr: transmit hardware errors
Mem: transmit memory errors Apn: transmit buffer errors
RX #: successful receives HwEr: receive hardware errors
Flag: receive invalid flag error Cksm: receive checksum error
Buf: receive buffer shortage Msg: receive message item shortage
Information
The Information screen displays software version date/time, verification of
valid Boot module, and programmed Network ID.
This screen is not editable.
DMX Monitor
The DMX Monitor screen displays the data for each active universe.
Press the joystick to cycle through all six ports. This screen is not
editable.
Series 400
The Series 400 screen is an obsolete menu item and should no longer be
used for Series 400 (Art-Net) setup. The new "Series 400 Setup" screen is
available when the Node has been loaded with Series 400 software, and
should be used to setup the Art-Net system as detailed in "Art-Net (Series
400) Mode" on page 18.
Virtuoso Node
000 001 002 003 -- --
DmxMon Virt NetSta
001
Network Stats
TX # 467 fail 0
T/O 0 HwEr 0
Mem 0 Apn 0
RX # 1262 HwER 0
Flag 0 Cksm 0
Buf 0 Msg 0
Virt NetSta Info
Information
Vers: 02/22/07 12:36
Boot: OK
NetId 00C0 5E02 03EC
NetSta Info Ser400
DMX Port 1 (000)
001: 000 127 255 127 255
006: 000 000 000 000 000
011: 000 000 000 000 000
016: 000 000 000 000 000
Ser400 DmxMon Virt
Series 400 Setup
000 001 002 003 004 005
numeric
Info Ser400 DmxMon
OBSOLETE MENU