Datasheet
SAFETY DATA SHEET
Page 3 / 6
PRF Silicon
Date 12.6.2017
Previous date: 15.11.2016
6. ACCIDENTAL RELEASE MEASURES
6.1
Personal precautions, protective equipment and emergency procedures
Prevent unauthorised persons entering the zone. Pay attention to the spreading of gases especially at ground
level (heavier than air) and to the direction of the wind.
6.2
Environmental precautions
Prevent product from entering drains.
6.3
Methods and materials for containment and cleaning up
not determined
6.4
Reference to other sections
not determined
7. HANDLING AND STORAGE
7.1
Precautions for safe handling
Do not use in areas without adequate ventilation. No sparking tools should be used. Do not taste or swallow. Do
not spray on a naked flame or any incandescent material. Do not smoke. Do not empty into drains. Do not store
near combustible materials. Take precautionary measures against static discharges. Prevent vapour buildup by
providing adequate ventilation during and after use.
7.2
Conditions for safe storage, including any incompatibilities
Do not store near combustible materials. Storage of flammable liquids
7.3
Specific end use(s)
not determined
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1
Control parameters
8.1.1
Threshold limits
106-97-8
800 ppm (8 h) 1000 ppm (15 min)
1900 mg/m
3
(8 h) 2350 mg/m
3
(15 min)
74-98-6
800 ppm (8 h) 1100 ppm (15 min)
1500 mg/m
3
(8 h) 2000 mg/m
3
(15 min)
64742-49-0
500 ppm (8 h) 630 ppm (15 min)
1800 mg/m
3
(8 h) 2300 mg/m
3
(15 min)
butan
propan
Naphtha(petroleum),
hydrotreatedlight
8.1.2
Other information on limit values
There is no data available for this product.
8.1.3
Limit values in other countries
There is no data available for this product.
8.1.4
DNELs
There is no data available for this product.
8.1.5
PNECs
There is no data available for this product.
8.2
Exposure controls
8.2.1
Appropriate engineering controls
not determined
8.2.2
Individual protection measures
8.2.2.1
Respiratory protection
Provide adequate ventilation. Do not inhale aerosol. Even in case of a full release, due to the small amount of
substances present, it is not expected that exposure limits will be reached.
8.2.2.2
Hand protection
It is good practice in industrial hygiene to avoid contact with solvents by using appropriate protective measures
whenever possible.