Assembly Instructions

1 Assemble the dome top unit:
Slide the small plastic dome cap (2) onto the
shaft of the hanger finial (1).
→
The threaded disk (3) has a raised ridge on the top
surface that sets into the hole of the dome top
(DT). The underside of the disk has three raised
ridges in the center for gripping/turning.
From the underside, set the threaded disk (3)
into place in the dome top (DT) opening.
Holding the disk in place, lower the cap/finial
(2)/(3) combo through the center hole in the
threaded disk. Screw the finial into the disk
for a snug fit. DO NOT OVERTIGHTEN.
Hang the swing (4) on the hook at the bottom
of the finial shaft.
Set assembled dome top unit aside.
2 Assemble the body of the cage:
→
Soft metal tabs are welded
to the inside vertical wire of the
left edge seam.
Bring the seams of the cage (C)
body together to complete the
circle. Bend the tabs around
the right vertical seam wire to
link the seams together.
Set assembled cage body aside.
steps
3
Assemble the base:
Insert one of the half tray (T) sections into the
opening at the bottom of the base (B), and slide it
all the way over to one side within the opening.
Insert the other tray half.
Set the removable grille (G) into place in the
bowl of the base.
4 Attach the cage body to the base:
→
Three plastic tabs protrude from the upper
rim of the base (B) to the interior bowl.
Catch the bottom rim wire of the cage (C)
body underneath each of the three tabs.
Secure the cage body to the base with
the three white plastic clamps, spread
equidistant around the cage rim.
Hook the top of the clamp to the horizontal
cage wire; hook the bottom of the clamp
under the rim of the base.
1
2
DT
C
3
4
B
T
T
G