User Manual

SPRAYER DIRECTIONS

FILL - Strain paint using a medium mesh (225-226 micron) strainer. Thin paints and

ﬁnishes using instructions supplied by the manufacturer. Pour strained paint or liquid

into the product container. Fill container to desired level, do not ﬁll the container

above the line on the shoulder. Screw safety cap into place. Shake up product in

product container prior to attaching to Sprayer.

ATTACH - Secure dip tube ﬁrmly into the bottom of the Sprayer. Remove the ﬁlter at

the bottom of the dip tube for latex paints and thick paints. Attach power unit, and

align red insert (1) opposite air vent (2) on coupler. Attach the product container into

the coupler by turning counter-clockwise. Once product container has been attached

to the power unit, NEvER ShAkE ThE SPRAYER. Shaking the Sprayer will disrupt the

spray and cause it to sputter or cease spraying. If this occurs stop and let the unit rest

for 45 seconds.

SPRAY - Start spraying with the Sprayer in motion and release the button while the

Sprayer is still moving at the end of the stroke to avoid runs. Overlap strokes, do not

tip past 45° or product can leak from the vent hole located at the bottom of the power

unit. The power unit is vented and, therefore, spraying between a 90º angle and 45º

angle is required or the unit will not work. Hold the sprayer upright, 6” to 10” from

the surface being sprayed (5” with lacquers and other quick drying ﬁnishes). If you

are too close to the surface, paint will build up too quickly and will run. If you are

too far away from the surface, the paint will dry before it reaches the surface and

dimpling will result. Keep the Sprayer moving constantly. For best results apply 2 or

more thin coats as opposed to 1 thick coat. Spray at room temperature. Begin your

project by spraying off workpiece, start to move back across, release button after

moving completely off workpiece, repeat process with 35%-50% overlap. Starting and

ﬁnishing off workpiece will lessen chance of “hot spotting” at beginning or ending of

paint stroke.

www.preval.com

815.634.5890

FILL AT TAC H SPRAY

Scan for Demo

PAGE 1
Scan for Demo FILL ATTACH SPRAY SPRAYER DIRECTIONS FILL - Strain paint using a medium mesh (225-226 micron) strainer. Thin paints and finishes using instructions supplied by the manufacturer. Pour strained paint or liquid into the product container. Fill container to desired level, do not fill the container above the line on the shoulder. Screw safety cap into place. Shake up product in product container prior to attaching to Sprayer. ATTACH - Secure dip tube firmly into the bottom of the Sprayer.
PAGE 2
How The Patented PREVAL Design Works Dispensed Spray Liquid from Jar Propellant When the button is pressed, propellant and liquid are mixed and dispensed as a spray at the nozzle by action of the venturi effect. Liquid from the jar is pulled up the tube as propellant travels across the holes in the red insert (inside the button). The propellant and liquid do not mix prior to being dispensed out of the nozzle.
PAGE 3
WARNINGS Flammable. Contents under pressure. Deliberate or intentional misuse by inhaling vapors may be harmful or fatal. Do not puncture or incinerate container. Do not expose to heat, sparks, open flame or store at temperatures in excess of 120° F (49° C). This is not a toy. Keep out of reach of children. Do not use with foods or pharmaceuticals. Work in a well ventilated area when mixing or spraying paint and other volatile liquids. Keep away from open flame. Avoid breathing fumes.