MSDS
MSDS633
PRESTONE POWER STEERING FLUID
FOR ASIAN VEHICLES
Date Prepared: 12/21/11
Page 2 of 5
EYE CONTACT: Exposed eyes should be immediately flushed with copious amounts of water using a steady, low-pressure
stream for several minutes. After the first few minutes, remove contact lenses, if present and easy to do so, then continue
flushing eyes. If irritation, pain, swelling or tearing persist, seek medical attention.
INGESTION: If swallowed, get immediate medical attention by calling an emergency room or poison control center. Do not
induct vomiting unless directed to do so by a physician. If medical advice cannot be obtained, then take the person and
product to the nearest medical emergency center or hospital. If vomiting occurs spontaneously, keep head below hips to
prevent aspiration into the lungs. Never give anything by mouth to a person who is unconscious or drowsy.
NOTES TO PHYSICIAN: There is no specific antidote. The petroleum oils and other ingredients in this product are unlikely
to produce systemic symptoms following accidental ingestion. Upon ingestion, there is a slight risk of aspiration in the lungs
which can lead to pneumonitis and non-cardiogenic pulmonary edema. If aspiration is suspected the patient should be
observed for sign of lung injury. The viscosity range of the product represented by this MSDS is greater than 100 SUS at 100°
F. Careful gastric lavage may be considered to evacuate large quantities of material. Treatment should be directed at the
control of symptoms and clinical conditions. Subcutaneous or intramuscular injection requires prompt surgical debridement.
There may be no signs of injury or pain initially. Failure to provide immediate treatment may result in extensive necrosis.
5. Firefighting Measures
EXTINGUISHING MEDIA: Use water fog, foam, carbon dioxide or dry chemical. Water or foam may cause frothing. Cool
fire exposed containers with water.
SPECIAL FIRE FIGHTING PROCEDURES: Firefighters should wear positive pressure self-contained breathing apparatus
and full protective clothing for fires in areas where chemicals are used or stored.
UNUSUAL FIRE HAZARDS: This product can burn but will not readily ignite. Vapors may be released when heated above
the flashpoint that can ignite when exposed to an ignition source. In enclosed spaces, heated vapor can ignite with explosive
force. Mists or sprays may burn at temperatures below the flashpoint. Containers may rupture from excessive heat.
HAZARDOUS COMBUSTION PRODUCTS: Burning may produce carbon monoxide, carbon dioxide, traces oxides of
sulfur, and nitrogen.
6: Accidental Release Measures
Wear appropriate protective clothing and equipment (See Section 8). Collect material with an inert absorbent material and
shovel into appropriate container for disposal. For large spill, recover free product by pumping and place in appropriate,
labeled container. Use caution when walking in spilled area. This product can create a slip hazard. Keep out of sewers,
watercourses and low areas.
7. Handling and Storage
Avoid contact with the eyes.
Avoid prolonged or repeated contact with skin and clothing.
Avoid breathing vapors or mists.
Use with adequate ventilation.
Wash exposed skin with soap and water after use.
Keep container away from excessive heat and open flames.
Keep containers closed when not in use.
Store in a cool, dry, well ventilated area.
Empty containers retain product residue and may be hazardous. Do not cut, weld, drill, etc. containers, even empty. Do not
reuse empty containers unless properly cleaned.