User's Manual

2.0 Operation
1. Install a charged Li-Ion battery
2. Set up the Motor Driver or Radio Dimmer. Apply power. Note the channel
setting. If the device being controlled is a Video Lens Control or Radio Dimmer,
set the mode to either Focus or Iris, so that it can be controlled by the Focus-Iris
unit.
3. Press the POWER button (5) momentarily. The power LED just above the switch
will light.
4. Use the push-button switches (7) to match the channel as shown in the display
(6) to the channel of the receiving unit.
5. Select the desired mode – focus or iris:
• If an MDR2 is being controlled, the Mode switch determines
which motor ( focus or iris) will respond to the control knob.
• If a Video Lens control is being used, the Mode setting of both
units must match (focus or iris).
6. When the Focus-Iris unit establishes communication with the Motor Driver or
Dimmer, the LINK LED (4) will glow. The color will indicate the signal strength as
described in the previous section.
7. The Control Knob (15) will now control either the motor or LED light.
8. The Camera Run LED located above the R/S Switch (3) indicates the camera
status.
9. To set Lens Limits:
a. Use the Control Knob to move the lens to one end of the desired range.
b. While pressing the SET BUTTON (9), turn the Control Knob until the lens
reaches the other end of the desired range.
c. Release the SET BUTTON.
d. The end limits of lens rotation are indicated by the solid glowing bars.
The moving bar shows the current lens position.
e. The limits can be removed by pressing the RESET button momentarily.
3.0 Specifications:
Size: 100mm x 77mm x 28mm (4” x 3” x 1.2” )
Weight: 340g (12 oz)
Typical operating time: 6 hours
Battery Type: 7.4V 1.5AH (FM50 enhanced type)
Charger: Sony BC-VM50 with US standard line plug.
Charger Operating voltage 100 – 240 VAC.
Charge Time: 4.5 hours